Set Vlan Name - 3Com 3CRWX120695A Command Reference Manual

set vlan name

Default — The aging timeout period is 300 seconds (5 minutes).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the aging timeout period
to 600 seconds for entries that match VLAN orange:
WX4400# set fdb agingtime orange age 600
success: change accepted.
See Also
"display fdb agingtime" on page 94
Creates a VLAN and assigns a number and name to it.
Syntax —
set vlan vlan-num name name
— VLAN number. You can specify a number from 2 through
vlan-num
4095.
— String up to 16 alphabetic characters long.
name
Default — VLAN 1 is named default by default. No other VLANs have
default names.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must assign a name to a VLAN (other than the default
VLAN) before you can add ports to the VLAN.
3Com recommends that you do not use the name default. This name is
already used for VLAN 1. 3Com also recommends that you do not
rename the default VLAN.
You cannot use a number as the first character in a VLAN name. 3Com
recommends that you do not use the same name with different
capitalizations for VLANs. For example, do not configure two separate
VLANs with the names red and RED.
set vlan name 103