Commands By Usage; System Log Commands; Clear Log - 3Com 3CRWX120695A Command Reference Manual

20
Commands by
Usage

clear log

S L
YSTEM
Use the system log commands to record information for monitoring and
troubleshooting. MSS system logs are based on RFC 3164, which defines
the log protocol.
This chapter present system log commands alphabetically. Use Table 94 to
locate commands in this chapter based on their use.
Table 94 System Log Commands by Usage
Type Command
System Logs "set log" on page 494
"set log trace mbytes" on page 496
"display log config" on page 492
"display log buffer" on page 490
"display log trace" on page 492
"clear log" on page 489
Clears the log messages stored in the log buffer, or removes the
configuration for a syslog server and stops sending log messages to that
server.
Syntax —
clear log [buffer | server ip-addr]
— Deletes the log messages stored in nonvolatile storage.
buffer
server ip-addr
log messages to the syslog server at this IP address. Specify an address
in dotted decimal notation.
Defaults — None.
C
OG OMMANDS
— Deletes the configuration for and stops sending