Dce-Dte Interface Commands; Ddtr Configuration - NetComm NTC-6000 Series Command Manual

DCE-DTE Interface commands

&D DTR Configuration
This parameter determines how the terminal responds when the DTR circuit
changes state.
Default: &D0
Command values:
&D0 Ignore DTR.
&D1 If in
online command state
connected.
&D2 If in
transition, the terminal performs an orderly clear-down of the call
and returns to
Automatic answer is disabled while DTR remains off.
Terminal "Auto-dials" default remote station (as determined by
&D3
^DHST) on off-to-on transition of DTR and enters
Terminal ends call and enters
of DTR.
Terminal "Auto-dials" default remote station (as determined by
&D4
^DHST) on on-to-off transition of DTR and enters
Terminal ends call and enters
of DTR.
&D5 When DTR is off pass all commands directly to the internal cellular
engine.
When DTR is on commands are processed by the NTC V.250
command interpreter, any commands not processed by the NTC
V.250 command interpreter are passed to the cellular engine in
accordance with the
NTC-6000 Series V.250 Manual
To suit software version 1.1.0
Storage:
online data state upon an on-to-off transition, the terminal enters
and issues an OK result code; the call remains
online data state or online command state
command state.
^PAST
Page 13 of 32
7/21/2010
&W
upon an on-to-off
online data
command state on on-to-off transition
online data
command state on off-to-on transition
parameter.
state.
state.