Replacement Of Cable Harness, Upper End - ABB IRB 6620LX Product Manual

4.3.3 Replacement of cable harness, upper end

Introduction
The cable harness 1-6 is undivided.
Replacing the cable harness is described in two steps:
This procedure details how to replace the upper end.
For description of how to replace the lower end, see
lower end (axes 1-2) on page
Location of cable harness
The cable harness for the axes 3 to 6 runs throughout the lower and upper arm as
shown in the figure below:
xx0600003078
A
B
C
D
E
F
G
Product manual - IRB 6620LX
3HAC035737-001 Revision: P
• lower end (axes 1-2)
• upper end (axes 3-6)
Cable harness
Metal clamp, at gearbox axis 3
Attachment screws, metal clamp at gearbox axis 3, M6x16 quality 8.8 (2 pcs)
Metal clamp, lower arm (2 pcs)
Attachment screws, metal clamp lower arm, M6x16 quality 8.8 (2+2 pcs)
Metal clamp, armhouse
Attachment screws, metal clamp armhouse, M6x16 quality 8.8 (2 pcs)
© Copyright 2009-2018 ABB. All rights reserved.
4.3.3 Replacement of cable harness, upper end
Replacement of cable harness,
189.
4 Repair
Continues on next page
195