Replacing The Cable Harness, Upper End (Incl. Axis 6) - ABB IRB 760 Series Product Manual

4.3.2 Replacing the cable harness, upper end (incl. axis 6)

Overview
Replacement of the cable harness is detailed in two steps - lower end (axes 1-3)
and upper end. The procedure below details replacement of the cable harness in
the upper end (incl. axis 6). The procedure for replacing the lower end (axis 1-3)
is detailed in section
Location of cable harness, upper end
The upper end of the cable harness is located as shown in the figure.
xx1000001176
Product manual - IRB 760
3HAC039838-001 Revision: M
4.3.2 Replacing the cable harness, upper end (incl. axis 6)
Replacing cable harness, lower end (axes 1-3) on page
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
153.
Continues on next page
163