Table of Contents
Advertisement
Chapter 2
2.3 Reset
2.4 Nexus connection
2.5 E1 connector
Note
R20UT0883ED0100 Rev. 1.00
User Manual
On the left side of the board a reset button is mounted. To adjust the threshold
voltage for the reset IC the potentiometer R113 is used. The delay between
power up and reset up can be varied with an additional capacitor into J24.
For additional information please consult the Data Sheet of the reset controller
(Texas Instruments, TLC7701ID).
The 20-pin Nexus debug cable from Renesas' debug tool (e.g. MiniCube) can be
connected to the Nexus Connector on the board.
The board is equipped with a 14-pin connector.
This connector can be used for the Renesas E1 Emulator and the flash
programmer PG-FP5.
Make sure that your PG-FP5 connection cable provides the new 14-pin plug and
not the old 16-pin plug.
For Flash programming, using the PG-FP5, power and clock must be supplied by
the Starter Kit Board. Please make sure to switch off power monitoring and enter
the right oscillator value in PG-FP5 setup.
General information
11
Advertisement
Table of Contents
