Installation Locations For The Calibration Tools - ABB IRB 760 Series Product Manual

5 Calibration

5.4.3 Installation locations for the calibration tools

5.4.3 Installation locations for the calibration tools
Location of fixed calibration items
This section shows how the robot is equipped with items for installation of
calibration tools for Axis Calibration (fixed calibration pins and/or bushings).
Installed calibration tools are not shown.
A fixed calibration pin and a bushing for the movable calibration tool are located
on each axis as follows.
If there is not enough space on an axis to install a fixed calibration pin, the axis is
equipped with two bushings instead, for installation of two calibration tools when
calibration is carried out. This is shown in the figure.
xx1600000700
The fixed calibration pin for axis 1 is installed on a removable tower. The tower will
need to be removed if electronic position switches are fitted to the robot. Keep the
tower in a safe location for future recalibration needs and mark it with robot serial
number to ensure that the correct one is refitted.
Continues on next page
364
© Copyright 2011-2018 ABB. All rights reserved.
Product manual - IRB 760
3HAC039838-001 Revision: M