ABB IRB 760 Series Product Manual page 119

2
3
4
Product manual - IRB 760
3HAC039838-001 Revision: M
Action
Make sure no additional stops are damaged.
Make sure the stops are properly attached.
Correct tightening torque, additional mechanical
stops:
• Axis 1 = 120 Nm.
If any damage is detected, the mechanical stops must
be replaced.
Correct attachment screws:
• Axis 1: M16 x 35, quality 12.9.
© Copyright 2011-2018 ABB. All rights reserved.
3.3.8 Inspecting the additional mechanical stops
Note
Shown in figure
mechanical stops on page
Article number is specified in
Required equipment on page
3 Maintenance
Continued
Location of
118.
118.
119