ABB IRB 760 Series Product Manual page 205

3
4
5
6
7
8
Product manual - IRB 760
3HAC039838-001 Revision: M
Action
Apply some grease in the hole for the bearings.
Fit two retaining rings for bores in the hole.
Fit the outer races of the bearings - one on
each side of the retaining rings.
Note
Check that the races are turned the correct way!
See figure!
Thread the sealing ring with dustlip and the in-
ner bearing complete on the presswasher of
the pressing tool, premounting bearings.
Apply the pressing tool and press the parts to-
gether.
Apply grease on the inner diameter of the
sealing ring with dustlip.
© Copyright 2011-2018 ABB. All rights reserved.
4.4.2 Replacing the tilthouse unit
Note
Art.no. is specified in Required equip-
ment on page 195.
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
xx1000001434
Parts:
A Surface for VK cover
B Outer race (close to VK cover)
C Outer race (inside retaining
rings)
D Retaining rings for bore
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Shown in the figure Press tool pre-
mounting bearing on page
Art.no. is specified in Required equip-
ment on page 195.
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Continues on next page
4 Repair
Continued
196.
205