4 Repair
4.3.3 Replacing the cable harness in the upper arm - IRB 2600ID
4.3.3 Replacing the cable harness in the upper arm - IRB 2600ID
Introduction
This procedure describes how to replace the cable harness in the upper arm on
IRB 2600ID.
Location of the cable harness in the upper arm - IRB 2600ID
The location of the cable harness in the upper arm is shown in the figure.
xx1000001000
A
B
C
D
E
Continues on next page
222
Note
In order to perform this procedure it is necessary to follow instructions in these
sections as well:
•
Replacing motor axis 5 - IRB 2600ID on page 329
•
Replacing motor axis 6 and wrist unit - IRB 2600ID on page 341
Bracket (inside armhouse)
Cover
Cable harness
Connectors motor axis 6 (2 pcs)
Bracket (securing cable harness to arm tube)
© Copyright 2009-2018 ABB. All rights reserved.
Product manual - IRB 2600
3HAC035504-001 Revision: Q