Refitting, parallel arm
Use this procedure to refit the parallel arm.
1
2
3
4
Product manual - IRB 760
3HAC039838-001 Revision: M
Action
Refitting of the parallel arm is best performed on a
workbench.
Apply some grease on the spacing sleeves on the
surfaces that face the parallel arm.
Refit a spacing sleeve on each shaft.
Refit a bearing on each shaft with pressing tool,
lower arm.
© Copyright 2011-2018 ABB. All rights reserved.
4.4.9 Replacement of parallel arm
Note
Specified in
Required equipment
on page 271
xx1000001376
Art. no. is specified in
equipment on page 271
xx1000001377
Continues on next page
4 Repair
Continued
Required
275