Table of Contents
Advertisement
1B-10 AIR CONDITIONING (OPTIONAL)
4
1
2
3
Condenser Assembly Removal and Installa-
tion
CAUTION:
Be careful not to damage condenser fins. If condenser fin
is bent, straighten it by using flat head screwdriver or
pair of pliers.
Removal
For Z13DT Engine Model
1) Disconnect negative (–) cable at battery.
2) Recover refrigerant from A/C system by referring to "Recov-
ery" in this section.
NOTE:
The amount of removed compressor oil must be mea-
sured for replenishing compressor oil.
3) Remove front bumper referring to "Front Bumper and Rear
Bumper" in Section 9.
4) Disconnect discharge hose (1) and liquid pipe (2) from con-
4
denser assembly (3).
5) Remove condenser bracket bolts (4).
6) Remove condenser assembly (3).
For M15 Engine Model
NOTE:
For M15 engine model, refer to the same section of the
Service Manual mentioned in the "Foreword" of this ser-
vice manual.
Installation
For Z13DT Engine Model
Reverse removal procedure to install condenser noting the follow-
ing instructions.
• Replenish specified amount of compressor oil to compressor
suction side by referring to "Replenishing compressor oil" in
this section.
• Evacuate and charge refrigerant by referring to "Evacuation
of A/C System" and "Charge" in this section.
Advertisement
Table of Contents
