Table of Contents
Advertisement
Input Shaft Speed Sensor
Inspection
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector (2).
3) Check resistance between input shaft speed sensor termi-
nals.
Input shaft speed sensor resistance
Standard: 560 – 680 Ω at 20°C (68°F)
1. Input shaft speed sensor
Removal
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector (2).
3) Remove input shaft speed sensor (1) by removing its bolt.
Installation
1) Apply A/T fluid to input shaft speed sensor O-ring.
2) Install input shaft speed sensor (1) to A/T case and tighten
bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
3) Connect input shaft speed sensor connector (2) to input
shaft speed sensor (1).
4) Connect negative cable to battery.
Throttle Position Sensor
Inspection
Check throttle position sensor referring to "Throttle Position Sen-
sor" in Section 6E1.
AUTOMATIC TRANSAXLE 7B-99
Advertisement
Table of Contents
