Table of Contents
Advertisement
7A-30 MANUAL TRANSMISSION
2) Insert each gear shift shaft into case and check that it moves
smoothly. If it doesn't, correct by using oilstone, reamer or
the like.
5th & Reverse Gear Shifter
1) Disassemble component parts by using special tool and
hammer.
Special tool
(A) : 09922-85811
2) Replace or correct parts as required and assemble shafts
making sure that component parts are in proper order as
shown in figure.
NOTE:
• Distinguish reverse gear shift arm spring (Blue) (2)
from low speed locating spring (Yellow).
• Install 2 steel balls (3) in reverse gear shift arm (1) with-
out fail.
• Drive in spring pin for reverse shift arm facing slit A
toward front.
1. Reverse gear shift arm
2. Reverse gear shift arm spring (Blue)
3. Steel ball
4. Spring pin
5. 5th & reverse gear shift shaft
DIFFERENTIAL ASSEMBLY
DISASSEMBLY
1) Using special tools, remove right bearing (1) and sensor
rotor (2).
Special tool
(A) : 09913-60910
(B) : 09925-88210
2) Remove left bearing in the same manner.
3) Support differential case with soft jawed vise and remove
final gear bolts then take out final gear.
6. 5th & reverse gear shift yoke
7. 5th & reverse gear shift guide shaft
8. 5th gear side
A: Face pin slit toward 5thn gear side
Advertisement
Table of Contents
