Suzuki Ignis Service Manual page 1021

9-14 BODY SERVICE
2
"a"
1
2
1
"a"
11) When reusing windshield, remove the adhesive (1) from it,
using care not to damage primer coated surface (2).
INSTALLATION
1) Using cleaning solvent, clean windshield edge where wind-
shield glass is to be adhered. (Let it dry for more than 10
minutes.)
2) Install new glass stoppers (1) (2 pieces) to lower side of
windshield.
1
3) To determine installing position of glass (1) to body (2), posi-
tion glass against body so that clearance between upper end
of glass (1) and body (2) is approximately 5 mm (0.197 in.)
and clearances between each side end (right & left) of glass
(1) and body (2) are even. Then mark mating marks on glass
(1) and body (2) as shown. Upper clearance can be adjusted
by moving glass stoppers position.
Windshield clearance
"a" : 5 mm (0.197 in.)
4) Clean contact surfaces of old adhesive (4), paint or bare
metal thoroughly.
If surfaces of paint or bare metal come out, apply primer (2)
for body with caution not to apply primer (2) to surface of
adhesive remaining on body.
NOTE:
• Be sure to refer to primer maker's instruction for
proper handling and drying time.
• Do not touch body and old adhesive surfaces where
glass is to be adhered.
1. Do not apply primer
3. Apply primer