Table of Contents
Advertisement
3D-4 FRONT SUSPENSION
On-Vehicle Service
Strut Assembly Removal and Installation
Installation
Install strut assembly by reversing removal procedure, noting the
following instructions.
• Insert bolts in such direction as shown in figure.
• Tighten all fasteners to specified torque.
Tightening torque
Strut bracket nut (a): 115 N·m (11.5 kg-m, 83.0 lb-ft)
Strut support nut (b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
Strut nut (c): 50 N·m (5.0 kg-m, 36.5 lb-ft)
CAUTION:
• Don't twist brake hose when installing it.
• Install E-ring (1) as far as it fits to bracket (2) as shown
in figure.
• Tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt:95 N·m (9.5 kg-m, 69.0 lb-ft)
• After installation, confirm front wheel alignment referring to
"Preliminary Checks Prior to Adjusting Front Wheel Align-
ment" in Section 3A.
Stabilizer Bar and Bushings Removal and
Installation
Installation
For installation, reverse removal procedure, noting the following
instructions.
• Install stabilizer bar (2) so that paint mark (1) on it comes to
the right side of vehicle.
Advertisement
Table of Contents
