Table of Contents
Advertisement
4A-10 FRONT DRIVE SHAFT
Assembly
For M15 engine model and right side shaft of Z13DT
engine model
CAUTION:
• Do not wash boots in degrease, such as gasoline or
kerosene, etc. Washing in degrease causes deteriora-
tion of boots.
• To ensure full performance of joint as designed, be
sure to distinguish two types of grease in spare part
and apply the specified amount of grease to each joint.
Judging from abnormality noted before disassembly and what is
found though visual check of each component after disassembly,
prepare replacement parts and start assembly, and make sure
that wheel side joint (1) and differential side joint (2) are washed
thoroughly and air dried, and boots (3) are cleaned with cloth if
they are to be reused.
[A] : Wheel side joint
[B] : Transaxle or transfer side joint
[1] : Left side shaft
[2] : Right side shaft
1) Wash each component (except boots). After wash, dry each
component completely by blowing air.
2) Clean boots with cloth.
3) Apply the specified amount of grease to the inside of joint
housing.
Grease color
For M15 engine model : Black
For right side shaft of Z13DT engine model : Black
Amount
For M15 engine model : 60 – 80 g (2.1 – 2.8 oz)
For right side shaft of Z13DT engine model :
75 – 95 g (2.6 – 3.4 oz)
4) Install wheel side boot on shaft, and then fasten boot big
band (1) by drawing hooks (2) with plier (3) and engage
hooks (4) in slot and window (5).
CAUTION:
• Place boot band against forward rotation (A).
• Do not squeeze or distort boot when fastening it with
bands. Distorted boot caused by squeezing air may
reduce its durability.
Advertisement
Table of Contents
