Suzuki Ignis Service Manual page 1522

(b)
(a)
Remounting
1) Make sure that torque converter is installed correctly to tran-
saxle.
Refer to "Unit Assembly" in this section.
WARNING:
Be sure to keep transaxle with torque converter horizon-
tal or facing up throughout the work. Should it be tilted
with torque converter down, converter may fall off and
cause personal injury.
2) Attach transaxle to engine.
Tightening torque
Transaxle and engine fastening bolts and nut
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
3) Tighten drive plate to torque converter bolts.
Align bolt hole of drive plate and torque converter then
tighten bolts through torque converter housing lower plate
opening.
Lock drive plate (1) by engaging flat head rod or the like (2)
with drive plate gear.
Tightening torque
Drive plate to torque converter bolts
(a): 19 N·m (1.9 kg-m, 14.0 lb-ft)
3. Wrench
4. Engine oil pan
4) Install lower stiffener (1).
Tighten lower stiffener bolts (a) first and next (b) with speci-
fied torque.
1
Tightening torque
Lower stiffener bolts
(a): 55 N·m (5.5 kg-m, 40 lb-ft)
(b): 55 N·m (5.5 kg-m, 40 lb-ft)
5) Install starter motor.
Tightening torque
Starter motor bolt and nut: 50 N·m (5.0 kg-m, 36.5 lb-ft)
6) Remount engine with transaxle assembly to vehicle. Refer to
"Engine Assembly Removal and Installation" in Section 6A1
for its procedure.
AUTOMATIC TRANSAXLE 7B-117