Suzuki Ignis Service Manual page 1230

NOTE:
• All suspension fasteners are an important attaching part in that it could affect the performance of
vital parts and systems, and/or could result in major repair expense. They must be replaced with
one of the same part number or with an equivalent part if replacement becomes necessary. Do not
use a replacement part of lesser quality or substitute design. Torque values must be used as speci-
fied during reassembly to assure proper retention of this part.
•
Never attempt to heat, quench or straighten any suspension part. Replace it with a new part, or damage
to the part may result
• For the items with asterisk (*) in the "CONTENTS" below, refer to the same section of the Service
Manual mentioned in "Foreword" of this manual.
General Description ........................................ 3E-2
Rear Suspension Component Locator ................ *
Rear Suspension Construction ..................... 3E-2
Diagnosis ......................................................... 3E-4
Rear Shock Absorber Check............................... *
Trailing Arm, Lateral Rod, Rear Axle, Rear
Axle (Housing) and Coil Spring Check................ *
Bump Stopper / spring Upper Seat Check .......... *
Rear Suspension Fasteners................................ *
Wheel Disc, Nut and Bearing Check............. 3E-4
On-vehicle Service .......................................... 3E-5
Lateral Rod Removal and Installation ................. *
Rear Shock Absorber Removal and
Installation ........................................................... *
Coil Spring Removal and Installation ............ 3E-5
Bump Stopper Removal and Installation....... 3E-6
SECTION 3E
REAR SUSPENSION
.
CONTENTS
Spring Upper Seat Removal and Installation ...... *
Trailing Arm Removal and Installation .......... 3E-6
Rear Axle Removal and Installation
(for 2WD Model)............................................ 3E-8
Wheel Bearing Removal and Installation
(for 2WD Model).................................................. *
Rear Axle Shaft and Wheel Bearing Removal
and Installation (for 4WD Model) ........................ *
Rear Axle Shaft Oil Seal Removal and
Installation (for 4WD Model) ............................... *
Rear Axle Housing Removal and
Installation (for 4WD Model) ....................... 3E-11
Tightening Torque Specifications ............... 3E-15
Required Service Material.................................... *
Special Tool........................................................... *
REAR SUSPENSION 3E-1
3E
3F
4A
5
5A
5B
5C
6
6A1
6B