Table of Contents
Advertisement
4) Tighten shock absorber lower bolts (1) (right & left) tempo-
rarily by hand.
5) Remove floor jack from rear axle.
6) Clean mating surface of rear axle (right & left) with brake
back plate and apply water tight sealant as shown in figure.
"A": Sealant 99000-31090
7) Install brake back plates (1) and tighten back plate bolts (2)
to specified torque.
Tightening torque
Brake back plate bolt (a): 23 N
8) Connect wheel speed sensor and lead wire clamps (right &
left) (if equipped with ABS).
REAR SUSPENSION 3E-9
·
m (2.3 kg-m, 17.0 lb-ft)
Advertisement
Table of Contents
