Suzuki Ignis Service Manual page 1095

10B-18 AIR BAG SYSTEM
Step
5 1) Measure voltage from "Q06-2" terminal of
SDM connector to body ground with ignition
switch ON.
Is it 8 V or more?
6 1) Remove and inspect "AIR BAG" bulb.
Is bulb good?
Fig. for STEP 2
Fig. for STEP 3 and 5
Fig. for STEP 4
NOTE:
Upon completion of inspection and repair work, perform following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
Action
Special tool
(A) : 09932-76010
1. 16-pin connector (for combination meter)
2. "YEL/BLK" wire terminal
Special tool
(A) : 09932-76010
Yes
Repair short from "YEL/
BLK" wire circuit (between
combination meter and
SDM) to power circuit.
Substitute a known-good
combination meter and
recheck.
No
Go to step 6.
Replace bulb.