Table of Contents
Advertisement
7A2-14 MANUAL TRANSAXLE (M15 ENGINE MODEL)
Transaxle Unit Dismounting and Remounting
Dismounting
Under hood
1) Remove battery and tray.
2) Undo wiring harness clamps, disconnect backup lamp switch
coupler, VSS coupler and ground cable.
3) Disconnect clutch cable from clutch release lever and
bracket.
4) Disconnect gear shift and select control cables.
5) Remove transaxle control cable bracket.
6) Remove water pipe bracket bolts from transaxle.
7) Remove transaxle to engine bolts (1).
8) Remove starting motor mounting bolt and nut.
9) Support engine by using lifting device.
On lift
10) Drain transaxle oil referring to "Manual Transaxle Oil
Change" in this section.
11) Remove left and right front drive shaft referring to "Front
Drive Shaft Assembly Removal and Installation" in Section
4A.
12) Remove center shaft referring to "Front Drive Shaft Assem-
bly Removal and Installation" in Section 4A (for FWD model).
13) Remove left side of engine under cover.
14) Remove starting motor referring to "Starting Motor Dis-
mounting and Remounting" in Section 6G.
15) Remove engine rear mounting bracket stiffener (1).
16) Remove clutch housing lower plate.
17) Remove engine rear mounting No.1 bracket (2) with No.2
bracket (3).
18) Remove transfer referring to "Transfer Dismounting and
Remounting" in Section 7D, if equipped.
19) Remove transaxle to engine bolts and nut.
20) Lower vehicle and support transaxle with transaxle jack.
Advertisement
Table of Contents
