Table of Contents
Advertisement
INSPECTION
Inspect clutch cable and replace it for any of the following condi-
tions.
• Excessive cable friction
• Frayed cable
• Bent or kinked cable
• Broken boots
• Worn end
INSTALLATION
1) Apply grease to cable end hook and also joint pin before
installing cable.
"A" : Grease 99000-25010
2) Hook cable end with pedal by using screwdriver or long nose
pliers from cabin inside, then join inner cable wire joint pin in
release lever.
3) Install clutch cable (2) to bracket (3) by turning cable cap (1)
about 90° as shown.
4) Screw in joint nut and adjust free travel of pedal to specifica-
tion by turning nut.
5) Check clutch for proper function with engine running.
NOTE:
Take care that cable grommet (4) has specific installing
direction as shown in the figure.
CLUTCH 7C-5
Advertisement
Table of Contents
