REAR WIPER AND WASHER SWITCH (IF EQUIPPED)
INSPECTION
Check for continuity between terminals at each switch position as
shown below.
If check result is not as specified, replace.
Position
(1) WIPER and WASHER ON
(2) WIPER ON
(3) OFF
(4) WASHER and WASHER ON
REAR WIPER MOTOR
INSPECTION
Wiper Motor
Use a 12 V battery to connect its (+) and (-) terminals to terminal
"L" and terminal "E" respectively. Then motor should rotate at 35
to 45 rpm.
Automatic Stop Operation
1) Connect battery positive terminal to terminal "L" and its neg-
ative terminal to terminal "E" and let the motor turn.
2) Disconnect terminal "L" from battery positive terminal and let
B
the motor stop.
L
E
3) Connect terminal "B" to battery positive terminal. Observe
the motor turns once again then stops at a specified position.
4) Repeat Step 1) to 3) several times, and check that the motor
stops at the specified position every time.
IGNITION KEY REMAINDER (IF EQUIPPED)
AND LIGHT REMAINDER WARNING BUZZER
REMOVAL
1) Remove combination meter. Refer to "COMBINATION
METER".
2) Remove buzzer unit (1) from combination meter.
INSTALLATION
Reverse removal procedure for installation.
BODY ELECTRICAL SYSTEM 8-25
Terminal
IG
LO
WA