Table of Contents
Advertisement
3) Remove differential side L bearing (1).
Drive it out by using special tool, bearing puller (2) and
press.
Special tool
(B) : 09913-80112
4) Remove pinion shaft pin.
Use special tool and hammer for its removal.
Special tool
(C) : 09922-85811
5) Remove pinion shaft (3), differential pinions with each
washer, differential gears (2) with each washer.
1. Differential case
ADJUSTMENT AND REASSEMBLY
Prepare replacing parts as required and proceed to reassembly.
Make sure that all parts are clean.
1) Install differential gears.
2) Measure and adjust thrust play referring to Section 7A.
If thrust play is out of specification, select suitable thrust
washer from among following available size, install it and
check again that specified gear play is obtained.
Available thrust washer thickness
: 0.9, 0.95, 1.0, 1.05, 1.1, 1.15 and 1.2 mm (0.035, 0.037,
0.039, 0.041, 0.043, 0.045, and 0.047 in.)
3) Then assemble them with suitable thrust washers.
4) Drive in new pinion shaft pin from right side till it is flush with
differential case surface.
Special tool
(C) : 09922-85811
1. Differential case
2. Differential gear
3. Differential pinion shaft
AUTOMATIC TRANSMISSION (4 A/T) 7B-113
Advertisement
Table of Contents
