(V)
4.75
3.8
0.5
180
Installation
For Z13DT Engine Model
Reverse removal sequence to install cooling unit, noting the fol-
lowing points.
• If cooling unit or evaporator is replaced, pour 25 cc of refrig-
• Install uniformly the padding (1) to installation hole.
• Evacuate and charge system according to previously
1
• Adjust heater control cable, referring to "Heater Control
• Enable air bag system, if equipped.
For M15 Engine Model
NOTE:
For M15 engine model, refer to the same section of the
Service Manual mentioned in the "Foreword" of this ser-
vice manual.
Pressure Sensor Inspection (Z13DT Engine)
1) Connect manifold gauge to A/C system and operate A/C
2) Check output voltage for pressure sensor (1) between GRY/
If it does not show such characteristic as shown in graph, replace
pressure sensor.
2600
3300
(kPa)
erating oil to compressor suction-side.
described procedure.
Lever Assembly Removal and Installation" in Section 1A.
system.
BLU and BRN/WHT, and then compare measured voltage
with specified voltage in graph.
AIR CONDITIONING (OPTIONAL) 1B-15