Table of Contents
Advertisement
FORWARD
2
FORWARD
2
INSPECTION
CAUTION:
• Do not connect a tester whatever type it may be.
3
• Never repair or disassemble SDM (3).
• If SDM has been dropped, or if there are cracks, dents
or other defects in the case or plate, replace it with a
new one.
• Check SDM (3) and SDM plate (5) for dents, cracks or defor-
mation.
• Check SDM connector (2) for damage, cracks or lock mech-
anism.
5
• Check SDM terminal for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
INSTALLATION
For installation, reverse removal procedure, nothing following
(a)
points.
• Ensure that arrow (4) on the SDM (3) is pointing toward the
3
front of the vehicle.
• Tighten SDM bolts to specified torque.
Tightening torque
SDM mounting bolt (a) : 6 N·m (0.6 kg-m, 4.5 lb-ft)
4
• Connect SDM connector (2) to SDM (3) securely.
• Enable air bag system. Refer to "ENABLING AIR BAG SYS-
TEM".
AIR BAG SYSTEM 10B-57
Advertisement
Table of Contents
