Suzuki Ignis Service Manual page 1282

9) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (b): 95 N·m (9.5 kg-m, 69.0 lb-ft)
10) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
Brake Drum Removal and Installation (for
4WD Model)
Installation
1) Before installing brake drum, check outer diameter "a" of
brake shoes. If it is not within value as specified below,
adjust it to specification by turning adjuster.
Brake shoes Measured brake
outer diameter = drum inside
"a" diameter
2) Install brake drum after making sure that inside of brake
drum and brake shoes are free from dirt and oil.
3) Tighten screw (1) to specified torque.
Tightening torque
Brake dram screw (a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
4) Upon completion of all jobs, depress brake pedal with about
300 N (30 kg, 66 lbs) load at least 15 – 20 times until
adjuster actuator clicking sound from drum brake can not be
heard so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable. For adjustment refer to "Parking
Brake Inspection and Adjustment" in Section 5.
5) Install console box cap if removed.
6) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (b): 95 N·m (9.5 kg-m, 69.0 lb-ft)
7) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
PARKING AND REAR BRAKE 5C-3
0.5 to 1.0 mm
–
(0.02 to 0.04 in.)