Suzuki Ignis Service Manual page 1327

6A1-4 ENGINE MECHANICAL (M15 ENGINE)
[A] : A/T vehicle
[B] : AWD vehicle
1. Engine right mounting
2. Engine right body side bracket
3. Engine left body side bracket
4. Engine left mounting
5. Engine left mounting bracket (for M/T vehicle)
5-1. Engine left mounting bracket (for A/T vehicle)
6. Engine rear mounting (for FWD vehicle)
6-1. Engine rear mounting (for AWD vehicle)
1
7. Engine rear mounting No.1 bracket
8. Engine rear mounting No.2 bracket
9. Engine rear mounting bracket stiffener
10. Engine right mounting nut
11. Engine right body side bracket bolt
12. Engine left mounting bolt
13. Engine left body side bracket bolt
14. Engine left mounting bracket nut
15. Engine left mounting bracket bolt
16. Engine left mounting bracket nut
Unit Repair Overhaul
4
3
2
Engine Assembly Removal and Installation
Removal
1) Relieve fuel pressure referring to "Fuel Pressure Relief Pro-
cedure" in Section 6.
2) Disconnect negative and positive cables at battery.
3) Remove engine hood after disconnecting windshield washer
hose.
4) Remove right and left side engine under covers.
5) Remove A/C compressor belt by referring to "Compressor
Drive Belt Replacement" in Section 1B (if equipped).
6) Drain engine oil referring to "Engine Oil and Filter Change" in
Section 0B.
7) Drain transaxle oil referring to "Manual Transaxle Oil
Change" in Section 7A2 (for M/T vehicle).
8) Drain A/T fluid referring to "Fluid change" in Section 7B (for
A/T vehicle).
9) Drain transfer oil referring to "Transfer Oil Change" in Sec-
tion 7D (for AWD vehicle).
10) Drain coolant by referring to "Cooling System Flush and
Refill" in Section 6B.
11) Disconnect MAF sensor coupler (1).
12) Remove air cleaner case (2) and resonator (3).
13) Remove canister purge hose (4) from EVAP canister purge
valve.
14) With hose connected, detach A/C compressor from its
bracket (if equipped).
NOTE:
Suspend removed A/C compressor at a place where no
damage will be caused during removal and installation of
engine assembly.
17. Engine rear mounting bolt
18. Engine rear mounting bolt
19. Engine rear mounting No.1 bracket bolt
20. Engine rear mounting No.2 bracket bolt
21. Engine rear mounting No.2 bracket bolt
22. Dynamic damper (for FWD vehicle)
23. Dynamic damper nut
Tightening torque