Table of Contents
Advertisement
0B-10 MAINTENANCE AND LUBRICATION
Exhaust System Inspection (Z13DT Engine)
WARNING:
To avoid danger of being burned, do not touch exhaust
system when it is still hot. Any service on exhaust sys-
tem should be performed when it is cool.
When carrying out periodic maintenance, or the vehicle is raised
for other service, check exhaust system as follows:
• Check rubber mountings for damage, deterioration, and out
of position.
• Check exhaust system for leakage, loose connections, dents
and damages.
If bolts or nuts are loose, tighten them to specification.
• Check nearby body areas for damaged, missing, or misposi-
tioned parts, open seams, holes, loose connections or other
defects which could permit exhaust fumes to seep into the
vehicle.
• Make sure that exhaust system components have enough
clearance from the underbody to avoid overheating and pos-
sible damage to the floor carpet.
• Any defects should be fixed at once.
Air Cleaner Filter Inspection (Z13DT Engine)
1) Remove air cleaner case clamps.
2) Take air cleaner filter out of case.
3) Check that filter is not excessively dirty, damaged or oily,
clean filter with compressed air from air outlet side of filter.
4) Install air cleaner filter and clamp upper case securely.
Air Cleaner Filter Replacement (Z13DT
Engine)
Replace air cleaner filter with new one according to steps 1), 2)
and 4) of inspection procedure.
Advertisement
Table of Contents
