Table of Contents
Advertisement
(a)
(b)
1
(a)
• Tighten mounting bolt and mounting bracket bolts and nuts
to specified torque.
Tightening torque
Transfer rear mounting bracket nuts
(a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
Transfer mounting bolt
(b) : 55 N·m (5.5 kg-m, 40.0 lb-ft)
(c)
Transfer rear mounting bracket No.2 bolts
(c) : 55 N·m (5.5 kg-m, 40.0 lb-ft)
• Tighten transfer stiffener bolts (4) to specified torque.
Tightening torque
Transfer stiffener bolts (a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
1. Transmission
2. Transfer
3. Stiffener
• Tighten exhaust pipe bolts.
Tightening torque
Exhaust pipe bolts
(a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
1. Exhaust No.1 pipe
2. Exhaust No.2 pipe
(a)
2
• Install right side drive shaft, refer to Section 4A.
• Install propeller shaft and tighten propeller shaft bolts and
center support bolts to specified torque (refer to Section 4B).
• Fill gear oil to transfer as specified, refer to OIL CHANGE of
ON-VEHICLE SERVICE.
Check oil level and leakage.
TRANSFER 7D-21
Advertisement
Table of Contents
