Table of Contents
Advertisement
4A-8 FRONT DRIVE SHAFT
1
1
7) Remove wheel side boot big band (1) as follows.
a) For boot big band without joint
i) Cut boot big band by using an iron saw or a nipper with
care not to damage wheel side joint housing.
b) For boot big band with joint
i) Draw hooks of boot big band together and remove band.
8) Remove wheel side small boot band, and then pull out wheel
side boot from shaft.
[A] : For boot big band without joint
[B] : For boot big band with joint
For left side shaft of Z13DT engine model
CAUTION:
Disassembly of wheel and differential side joints is not
allowed. If any abnormality is found, replace it as assem-
bly.
1) Remove differential side boot big band (1) by using flat end
rod or the like.
2) Remove differential side joint from shaft as follows.
a) Gather boot and remove old grease so that circlip (1) is vis-
ible.
Advertisement
Table of Contents
