Table of Contents
Advertisement
9-16 BODY SERVICE
3
2
1
"b"
"a"
"c"
2
3
1
"b"
"a"
"d"
9) Apply primer for molding along molding surface all around.
10) Apply adhesive (1) referring to figure.
NOTE:
• Press glass (2) against fittings surface of body panel
• Use of rubber sucker grip is helpful to hold and carry
• Perform steps 8) to 9) within 10 min. to ensure suffi-
• Be sure to refer to adhesive maker's instruction for
2
• Start from bottom side of glass (2).
• Be careful not to damage primer.
Adhesive amount specifications and position for wind-
shield
Width "a" : Approx. 7 mm (0.27 in.)
Height "b" : Approx. 15 mm (0.59 in.)
Position "c" : Approx. 10 mm (0.39 in.) for front, rear and
2
upper sections
Position "d" : Approx. 17 mm (0.67 in.) for bottom section.
3
1
"b"
"a"
"c"
11) Holding rubber sucker grips (1), place glass onto body by
aligning mating marks marked in step 3) and press it.
12) Check for water leakage by pouring water over windshield
through hose. If leakage is found, dry windshield and fill
leaky point with adhesive. If water still leaks even after that,
remove glass and start installation procedure all over again.
NOTE:
• Do not use high pressure water.
• Do not blow compressed air directly at adhesive
• Do not use infrared lamp or like for drying.
quickly after adhesive (1) is applied.
glass after adhesive (1) is applied.
cient adhesion.
proper handling and drying time.
3. Molding
applied part when drying.
Advertisement
Table of Contents
