Table of Contents
Advertisement
6A1-8 ENGINE MECHANICAL (M15 ENGINE)
(a)
1
(a)
10) Install exhaust No.1 pipe referring to "Exhaust Manifold
11) Reverse disconnected hoses, cables and electric wires for
12) Install air cleaner case and resonator.
13) Install A/C compressor to its bracket (if equipped).
14) Adjust A/C compressor belt tension (if equipped) referring to
15) Adjust accelerator cable play referring to "Accelerator Cable
16) Check to ensure that all removed parts are back in place.
17) Refill cooling system with coolant referring to "Cooling Sys-
18) Refill engine with engine oil referring to "Engine Oil and Filter
19) Refill transaxle with transaxle oil referring to "Manual Tran-
20) Refill A/T fluid referring to "Fluid change" in Section 7B (for
21) Refill transfer with transfer oil referring to "Transfer Oil
22) Connect negative cable at battery.
23) Verify that there is no fuel leakage, coolant leakage, oil leak-
Main Bearings, Crankshaft and Cylinder
Block Inspection
Main bearings
General Information
7) Install cross member (1).
Tighten bolts to specified torque.
Tightening torque
Cross member bolts
(a) : 60 N·m (6.0 kg-m, 43.0 lb-ft)
8) For AWD vehicle, install propeller shaft referring to "Propel-
ler Shaft Removal and Installation" in Section 4B.
9) Connect drive shaft joints referring to Section 4A.
Removal and Installation" in this section.
connection.
"Compressor Drive Belt Inspection and Adjustment" in Sec-
tion 1B.
Adjustment" in Section 6E1.
Reinstall any necessary parts which have not been rein-
stalled.
tem Flush and Refill" in Section 6B.
Change" in Section 0B.
saxle Oil Change" in Section 7A2 (for M/T vehicle).
A/T vehicle).
Change" in Section 7D (for AWD vehicle).
age and exhaust gas leakage at each connection.
• Service main bearings are available in standard size and
0.25 mm (0.0098 in.) undersize, and each of them has 5
kinds of bearings differing in tolerance.
Advertisement
Table of Contents
