Diagnosis; Diagnostic Trouble Code (Dtc); Use Of Special Tool - Suzuki Ignis Service Manual

10B-6 AIR BAG SYSTEM
CONNECTOR "Q06" (SDM connector)
TERMINAL
Q06-1
Q06-2 "AIR BAG" warning lamp
Q06-3
Q06-4 Ignition switch (power source)
Q06-5 Passenger pretensioner
(if equipped)
Q06-6
Q06-7 Passenger air bag (inflator)
module
Q06-8
Q06-9 Driver air bag (inflator)
module
Q06-10
WARNING:
To avoid deployment when troubleshooting the air bag system, do not use electrical test equipment
such as a battery powered or AC powered voltmeter, ohmmeter, etc., or any type of electrical equip-
ment other than that specified in this manual. Do not use a non-powered probe type tester.
Instructions in this manual must be followed carefully, otherwise personal injury may result.

DIAGNOSTIC TROUBLE CODE (DTC)

The AIR BAG DIAGNOSTIC SYSTEM CHECK must always be the starting point of any air bag system diagno-
sis. The AIR BAG DIAGNOSTIC SYSTEM CHECK checks for proper "AIR BAG" warning lamp operation and
checks for air bag diagnostic trouble codes (DTCs) using on-board diagnosis function or SUZUKI scan tool.

USE OF SPECIAL TOOL

WARNING:
To avoid deployment when troubleshooting the air bag system, do not use electrical test equipment
such as a battery powered or AC powered voltmeter, ohmmeter, etc., or any type of electrical equip-
ment other than that specified in this manual. Do not use a non-powered probe type tester.
Instructions in this manual must be followed carefully, otherwise personal injury may result.
You should be familiar with the tools listed in this section under the heading SPECIAL TOOLS. You should be
able to measure voltage and resistance. You should be familiar with proper use of a scan tool such as Air Bag
Driver/Passenger Load Tool, Connector Test Adapter Kit and the Digital Multimeter.
CIRCUIT
–
–
High
Low
High
Low
Low
High

DIAGNOSIS

Special tool
(A) : 09932-76010 (Connector Test Adapter Kit)
This must be used whenever a diagnostic procedure requests
checking or probing a terminal.
Using the appropriate adapter in the special tool will ensure that
no damage to the terminal will occur from the multimeter probe,
such as spreading or bending.
TERMINAL
Q06-11 Driver pretensioner
(if equipped)
Q06-12
Q06-13
Q06-14 Data link connector (DLC)
Q06-15 Diagnosis switch
Q06-16
Q06-17 Ground
Q06-18
Q06-19
Q06-20
CIRCUIT
Low
High
–
–
–
–
–