Table of Contents
Advertisement
"a"
[A]
12) Apply grease in the supplied parts to the inside of differential
side joint housing.
Grease color : Dark brown
Amount : Approximately 80 g (2.8 oz)
13) Place differential side joint onto spline of drive shaft and
drive onto drive shaft by using plastic hammer until circlip
engages.
14) Fit boot to grooves of shaft and housing and adjust length "a"
to specification below. Insert screwdriver into boot and allow
air to enter boot so that air pressure in boot becomes the
same as atmospheric pressure.
Drive shaft boot fixing position
"a" : Approximately 168.7 mm (6.64 in.)
A : Differential side
CAUTION:
Do not squeeze or distort boot when fastening it with
bands. Distorted boot caused by squeezing air may
reduce its durability.
15) Install and fasten new boot big and small bands at that posi-
tion of step 14) in the same procedure as steps 6) to 9).
Center Shaft and Center Bearing Support Dis-
assembly and Assembly
Disassembly
1) For M/T vehicle, go to the next step. For A/T vehicle, remove
wheel side oil seal and circlip from center bearing support
bracket (3).
2) Using hydraulic press (1), draw out center shaft (2) from cen-
ter shaft support bearing.
3) Remove oil seals from center bearing support bracket (3).
FRONT DRIVE SHAFT 4A-15
Advertisement
Table of Contents
