Suzuki Ignis Service Manual page 1328

9
10
11
7
5
4
3
31
29
6
17
14
15 25
[A]
26
19
24
[B]
27
22
19
21
15) Disconnect the following electric lead wires:
• TP sensor (1)
• MAP sensor (2)
• ECT sensor (3)
• EGR valve (4)
• CMP sensor (5)
• IAC valve (6)
• Ignition coil assembly (7)
• Injectors (8)
• Heated oxygen sensor (9)
• Oil control valve (10)
8
• Engine oil pressure switch (11)
• CKP sensor (12)
2
• Knock sensor (13)
20
• VSS (14)
23
• Back up light switch (15) (for M/T vehicle)
1
• Generator (16)
• Starting motor (17)
30
• Ground terminal (18) from cylinder block
• Battery ground cable (19) from transaxle
13 16
• Transmission range switch (20) (for A/T vehicle)
• A/T shift solenoid and A/T fluid temperature sensor (21) (for
A/T vehicle)
• Input shaft speed sensor (22) (for A/T vehicle)
• Magnet clutch switch of A/C compressor (if equipped)
18 12
• Each wire harness clamps
16) Remove fuse box from its bracket.
17) Disconnect the following cables :
• Accelerator cable (23)
• Gear select control cable (24) (for M/T vehicle)
• Gear shift control cable (25) (for M/T vehicle)
• Clutch cable (26) (for M/T vehicle)
• A/T selector cable (27) (for A/T vehicle)
18) Disconnect the following hoses :
20
• Brake booster hose (28) from intake manifold
• Radiator inlet and outlet hoses (29) from each pipe
• Heater inlet and outlet hoses (30) from each pipe
• Fuel feed hoses (31) from fuel feed pipe
• A/T fluid hoses from radiator (for A/T vehicle)
[A] : M/T vehicle
[B] : A/T vehicle
19) Remove exhaust No.1 pipe referring to "Exhaust Manifold
Removal and Installation" in this section.
20) Disconnect right and left drive shaft joints to differential gear
referring to "Drive Shaft Assembly Removal and Installation"
in Section 4A.
For engine and transaxle removal, it is not necessary to
remove drive shafts from steering knuckle.
21) For AWD vehicle, remove propeller shaft referring to "Pro-
peller Shaft Removal and Installation" in Section 4B.
ENGINE MECHANICAL (M15 ENGINE) 6A1-5