Table of Contents
Advertisement
REMOUNTING
Reverse removal procedure for installation, noting the following.
Rear Differential
Rear Axle Shaft
For installation of rear axle shaft, refer to "REAR AXLE SHAFT
AND WHEEL BEARING INSTALLATION" in Section 3E.
Rear Brake Drum
For installation of rear brake drum, refer to "BRAKE DRUM
INSTALLATION" in Section 5.
Differential Gear Oil
Refill differential housing with new specified oil. Refer to "OIL
CHANGE" in this section for refill.
Brake Circuit Air Purging
Make sure to purge air out of brake circuit. Refer to "BLEEDING
BRAKES" in Section 5.
Then check to ensure that joint seam of pipe is free from oil leak.
UNIT DISASSEMBLY
Remove bolts (1) and separate viscous coupling case from differ-
1
ential carrier.
• Clean mating surfaces of axle housing (1) and differential
carrier and apply sealant to housing side.
"A" : Sealant 9900-31110
• Install differential carrier assembly to axle housing and
tighten carrier bolts to specified torque.
Tightening torque
Differential carrier bolts
(a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
• Install propeller shaft to joint flange aligning match marks (2)
and tighten propeller shaft bolts to specified torque.
Tightening torque
Propeller shaft bolts
(b) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
REAR DIFFERENTIAL 7F-7
Advertisement
Table of Contents
