Table of Contents
Advertisement
NOTE:
• All front suspension fasteners are an important attaching part in that it could affect the perfor-
mance of vital parts and systems, and/or could result in major repair expense. They must be
replaced with one of the same part number or with an equivalent part if replacement becomes nec-
essary. Do not use a replacement part of lesser quality or substitute design. Torque values must be
used as specified during reassembly to assure proper retention of this part.
• Never attempt to heat, quench or straighten any front suspension part. Replace it with a new part or
damage to the part may result.
• For the items with asterisk (*) in the "CONTENTS" below, refer to the same section of the Service
Manual mentioned in "Foreword" of this manual.
General Description ........................................3D-2
Front Suspension Construction.....................3D-2
Diagnosis .........................................................3D-3
Diagnosis Table .................................................. *
Stabilizer Bar and Bushing Check....................... *
Strut Assembly Check......................................... *
Suspension Control Arm / Steering
Knuckle Check .................................................... *
Suspension Control Arm Joint Check ................. *
Front Suspension Fasteners Check.................... *
Wheel Disc, Nut and Bearing Check.............3D-3
On-Vehicle Service .........................................3D-4
Strut Assembly Component ................................ *
Strut Assembly Removal and Installation......3D-4
Strut Assembly Disassembly and
Assembly............................................................. *
SECTION 3D
FRONT SUSPENSION
CONTENTS
Stabilizer Bar and Bushings Component ............ *
Stabilizer Bar and Bushings Removal
and Installation.............................................. 3D-4
Wheel Hub and Steering Knuckle
Component ......................................................... *
Wheel Hub and Steering Knuckle
Removal and Installation............................... 3D-5
Wheel Hub and Steering Knuckle
Disassembly and Assembly ................................ *
Suspension Control Arm / Bushing
Removal and Installation..................................... *
Suspension Control Arm / Bushing
Disassembly and Assembly ................................ *
Tightening Torque Specifications ................. 3D-7
Required Service Material.................................... *
Special Tool........................................................... *
FRONT SUSPENSION 3D-1
0A
0B
1A
1B
3B
3D
3E
3F
4A
5
5A
5B
5C
6
6A1
6B
Advertisement
Table of Contents
