Table of Contents
Advertisement
CAUTION:
Use care not to allow grease or dirt to be attached on the
printed circuit board and the battery.
NOTE:
• To prevent theft, be sure to break the transmitter
before discarding it.
• Dispose of the used battery properly according to
applicable rules or regulations. Do not dispose of lith-
ium batteries with ordinary household trash.
CODE REGISTRATION PROCEDURE
1) Confirm that IG switch is OFF position.
2) Remove DOOR LOCK fuse and install it again.
3) Press the button on the transmitter one time toward the
receiver within 30 seconds.
4) If two transmitters are registered, repeat step 1) to 3) with
other transmitter.
NOTE:
• Two transmitter codes can be registered.
• When a new transmitter is registered, the oldest one
will be cleared.
POWER DOOR MIRROR CONTROL SYSTEM
(IF EQUIPPED)
MIRROR SWITCH
INSPECTION
1) Remove mirror switch from instrument panel.
2) Check for continuity between terminals at each switch posi-
tion as show below.
If check result is not as specified, replace mirror switch.
L
a
b
R
UP
DOWN
LEFT
RIGHT
BODY ELECTRICAL SYSTEM 8-31
d
g
c
e
f
Advertisement
Table of Contents
