Table of Contents
Advertisement
NOTE:
• Up to 4 Transponder codes for ignition key with a built-in transponder can be registered.
• It is not possible to register the same Transponder code for ignition key with a built-in transponder
as the one already registered in Immobilizer Control Module.
PROCEDURE AFTER ECM REPLACEMENT
When ECM was replaced, including when replaced because rechecking by using a known-good ECM was nec-
essary during trouble diagnosis, register ECM/Immobilizer Control Module code in ECM by performing following
procedure.
1) Perform steps 1) and 2) described in "How To Register Ignition Key". And then turn ignition switch ON.
2) Using SUZUKI scan tool, register ECM/Immobilizer Control Module code in ECM by executing "RECORD
ECU (RECORD ECM/lCM)" command in SELECT MODE menu.
NOTE:
For operation procedure of SUZUKI scan tool, refer to SUZUKI scan tool operator's manual.
3) Make sure that malfunction indicator lamp lights when ignition switch is turned OFF once and then ON.
09931-76011
Tech 1A kit
See NOTE below.
NOTE:
This kit includs the following items.
1. Storage case, 2. Operator's manual, 3. Tech 1A, 4. DLC cable, 5. Test lead/probe,
6. Power source cable, 7. DLC cable adaptor, 8. Self-test adaptor
SPECIAL TOOL
Immobilizer cartridge of
version 1.1 or more
IMMOBILIZER CONTROL SYSTEM 8G-25
09931-76030
16/14 pin DLC cable
Mass storage cartridge of
version 1.5 or more
Advertisement
Table of Contents
