Table of Contents
Advertisement
7A2-24 MANUAL TRANSAXLE (M15 ENGINE MODEL)
1
6) Install 5th gear (1) to counter shaft facing machined boss A
inward.
A : Machined boss (Inside)
B : No machining (Outside)
7) Install needle bearing of separated steel cage type to input
shaft, apply oil then install 5th gear (1) and special tool to
(A)
stop shaft rotation.
Special tool
2, (a)
(B) : 09927-76060
8) Tighten new counter shaft nut (2) to specified torque, and
caulk counter shaft nut (2) securely.
Tightening torque
counter shaft nut (a) : 100 N·m (10.0 kg-m, 75.0 lb-ft)
9) Fit 5th gear shift fork (1) to sleeve (3) and hub (2) assembly,
and install them to input shaft and gear shift shaft aligning
punch mark (4) with matching mark (5) on input shaft.
Advertisement
Table of Contents
