7A2-32 MANUAL TRANSAXLE (M15 ENGINE MODEL)
(A)
Assembly
NOTE:
Before installation, wash each part and apply specified
transaxle oil to sliding faces of bearing and gear.
1) If input shaft oil seal (1) has been removed, install it with its
spring side facing upward.
Use special tool and hammer for installation and apply
grease to oil seal lip.
"B" : Grease 99000-25010
Special tool
(A) : 09913-84510
2) If counter shaft right bearing cup (2) has been removed,
install it using special tools and hammer.
Special tool
(B) : 09925-98210
(C) : 09924-84510
3) Install differential side bearing outer race to right case using
special tool and hammer.
Special tool
(A) : 09913-85210
4) Install gear shift shaft, input shaft and counter shaft referring
to "Gear Shift Shaft, Input Shaft and Counter Shaft Removal
and Installation" in this section.
Transaxle Left Case Disassembly and Assem-
bly
Disassembly
1) Replace differential side oil seal from left case referring to
"Differential Side Oil Seal Replacement" in this section, if
necessary.