Diagnostic Trouble Code (Dtc) Check (Immobilizer Control Module) - Suzuki Ignis Service Manual

1
(A)
(C)
DIAGNOSTIC TROUBLE CODE (DTC) CHECK
(IMMOBILIZER CONTROL MODULE)
1) Turn ignition switch OFF.
2) After setting cartridge to Suzuki scan tool, connect it to data
link connector (DLC) (1) located on underside of instrument
panel at driver's seat side.
Special tool
(A) : 09931-76011 (Suzuki scan tool)
(B) : Mass storage cartridge
(C) : 09931-76030 (16/14 pin DLC cable)
3) Turn ignition switch ON.
4) Read DTC stored in immobilizer control module according to
instructions displayed on Suzuki scan tool and print it or
write it down. Refer to Suzuki scan tool operator's manual for
further details.
If communication between Suzuki scan tool and immobilizer
control module is not possible, go to "Diagnostic Flow Table
C".
NOTE:
(B)
When reading DTC stored in immobilizer control module
using Suzuki scan tool, select "BCM" from the applica-
tions menu and "IMMOBILIZER" from the select system
menu displayed on Suzuki scan tool.
5) After completing the check, turn ignition switch OFF and dis-
connect Suzuki scan tool from data link connector (DLC).
IMMOBILIZER CONTROL SYSTEM 8G-7