Table of Contents
Advertisement
18) Remove engine left mounting (1) with bracket (2).
19) Remove other attached parts from transmission, if any.
20) Pull transmission out so as to disconnect input shaft from
clutch disc and then lower it.
REMOUNTING
CAUTION:
Care should be taken not to scratch oil seal lip with drive
shaft while raising transmission.
Do not hit drive shaft joint with hammer when installing it
into differential gear.
Remount transmission in reverse order of dismounting procedure
noting the following.
• Refer to Section 7D for installing transfer (if equipped).
• Refer to the first figure of "UNIT REPAIR OVERHAUL" for
fastener specified torque.
• Push in drive shaft joints (right & left) fully so as to snap ring
of shaft engages with differential gear.
• Set each clamp for wiring securely.
• After connecting clutch cable, be sure to adjust its play prop-
erly.
Refer to Section 7C.
• Fill transmission with oil as specified.
• Connect battery and check function of engine, clutch and
transmission.
UNIT DISASSEMBLY
FIFTH GEARS
1) Remove side cover bolts and take off transmission side
cover.
CAUTION:
Care should be taken not to distort side cover when it is
removed from left case.
MANUAL TRANSMISSION 7A-17
Advertisement
Table of Contents
