Table of Contents
Advertisement
7B-166 AUTOMATIC TRANSAXLE
Inspection
1) Hold differential case subassembly with soft jawed vice and
set special tools as shown.
Special tool
(A): 09900-20607
(B): 09900-20701
2) Measure differential gear thrust play.
Differential gear thrust play:
0.05 – 0.20 mm (0.002 – 0.008 in.)
3) If thrust play is out of specification, replace differential case
subassembly.
Assembly
WARNING:
• When taking warmed final driven gear out of vessel,
use tongs or the like. Taking out it with bare hand will
cause severe burn.
• While installing warmed final driven gear, use oven
glove such as leather glove. Picking up it with bare
hand may cause burn.
CAUTION:
Do not leave final driven gear in boiling water for longer
than 5 min. Overheating the gear may cause strength
reduction of gear.
1) Put final driven gear in water vessel, heat and remove when
it boils, then remove moisture.
NOTE:
After removing moisture on final driven gear, install final
driven gear to differential case as quickly as possible.
2) As shown in figure, facing groove (2) side upward, install
final driven gear (1) to differential case.
Advertisement
Table of Contents
