Table of Contents
Advertisement
1
2
1
Replenishing compressor oil
2
NOTE:
For M15 engine model, refer to the same section of the
Service Manual mentioned in the "Foreword" of this ser-
vice manual.
For Z13DT Engine Model
It is necessary to replenish specified amount of compressor oil to
compressor (1) from compressor suction side hole (2) before
evacuating and charging refrigerant.
When Charging Refrigerant Only
When evacuating and charging refrigerant without replacing any
component part, replenish the same amount of measured oil
when recovering refrigerant (if not measured, replenish 30 cc oil).
When Replacing Compressor
CAUTION:
Be sure to use P/N: 99000-990C5-00A compressor oil or
an equivalent compressor oil.
Compressor oil is sealed in each new compressor by the amount
required for A/C system. Therefore, when using a new compres-
sor for replacement, drain oil from it by the amount calculated as
follows.
"C" = "A" – "B"
"C": Amount of oil to be drained
"A": Amount of oil sealed in a new compressor
"B": Amount of oil remaining in removed compressor
NOTE:
Compressor assembly supplied from factory is filled up
with the following amount of oil.
Oil amount in compressor
3
100 cm
(100 cc, 6.1 in
1. New compressor
2. Removed compressor
Procedure After ECM Replacement (Z13DT
Engine Model)
Refer to "Procedure after ECM replacement" under "ECM Regis-
tration" in Section 6E3.
AIR CONDITIONING (OPTIONAL) 1B-9
3
)
Advertisement
Table of Contents
