Table of Contents
Advertisement
On-vehicle Service
Coil Spring Removal and Installation
Installation
1) Install coil spring (1) on spring seat (2) of rear axle (or axle
housing) and mate spring open end with stepped part (3) of
spring lower seat and raise rear axle (or axle housing).
A : Upper side
"a" Small
"b" Large
2) Install shock absorber (1) lower side to rear axle (or axle
housing).
Tighten shock absorber lower bolt (2) temporarily by hand at
this step.
3) Install lateral rod (1) to vehicle body, refer to the figure for
proper installing direction of bolt (2).
Tighten nut (3) temporarily by hand at this step.
4) Remove floor jack from rear axle (or axle housing).
[A]: 2WD model
[B]: 4WD model
F: Forward
5) Install brake flexible hose E-ring.
6) Install LSPV spring to rear axle. Tighten LSPV adjust nut
temporarily at this step (if equipped with LSPV).
7) Install wheel (1) and tighten wheel bolts (2) to specified
torque.
Tightening torque
Wheel bolt (a): 95 N·m (9.5 kg-m, 69.0 lb-ft)
REAR SUSPENSION 3E-5
Advertisement
Table of Contents
