Table of Contents
Advertisement
5) Clean mating surfaces of axle housing (1) and differential
carrier and apply sealant to housing side.
"A": Sealant 99000-31110
6) Apply sealant to thread part of carrier bolts and tighten car-
rier bolts to specified torque.
"A": Sealant 99000-31110
Tightening torque
Rear differential carrier bolt
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
7) Install propeller shaft to joint flange aligning match marks (2)
and tighten flange bolts to specified torque.
Tightening torque
Companion flange bolt (b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
8) Remove floor jack from axle housing.
9) Connect brake flexible hoses (2) (right & left) to bracket on
axle housing and secure it with E-rings (1).
Tightening torque
Brake pipe flare nut (C): 16 N·m (1.6 kg-m, 11.5 lb-ft)
10) Apply grease to rear axle shaft oil seals (1) lip (right & left) as
shown.
"A": Grease 99000-25010
11) Clean mating surface (2) (right & left) of rear axle housing
and brake back plate and apply sealant as shown in figure.
"B": Sealant 99000-31090
12) Install rear axle shaft (right & left) to rear axle housing.
13) Tighten brake back plate bolts to specified torque.
Tightening torque
Brake back plate bolt (a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
14) Connect brake pipes (3) to wheel cylinders (1) (right & left)
and tighten brake pipe flare nuts (2) to specified torque.
Tightening torque
Brake pipe flare nut (b): 16 N·m (1.6 kg-m, 11.5 lb-ft)
REAR SUSPENSION 3E-13
Advertisement
Table of Contents
