Suzuki Ignis Service Manual page 1131

10B-54 AIR BAG SYSTEM
• Steering wheel and driver air bag (inflator) module
– Check for damage or air bag (inflator) module fitness.
– Check trim cover (pad surface) for cracks.
– Check wire harness and connector for damage or tight-
ness.
If any faulty condition is found in above checks, replace faulty
part.
• Contact coil and combination switch assembly
– Check wire harness and connectors for damage or tight-
ness.
– Check contact coil case for damage.
If any faulty condition is found in above checks, replace.
• SDM and SDM plate
– Check for external damage such as deformation, scratch,
crack, peeled paint, etc.
– Check that SDM cannot be installed properly due to a
cause in itself. (There is a gap between SDM and SDM
plate, or it cannot be fixed securely.)
– Check that connector or lead wire of SDM has a scorching,
melting or damage.
– Check SDM connector and terminals for tightness.
– Check SDM sets a diagnostic trouble code (Refer to "DTC
CHECK".) and the diagnostic table leads to a malfunction-
ing SDM.
If any faulty condition is found in above checks, replace.
• Instrument panel member and reinforcement
– Check for any distortion, bending, cracking or other dam-
age.
If any faulty condition is found in above checks, replace.
• Passenger air bag (inflator) module
– Check for dents, cracks, damage or fitness.
– Check trim cover for cracks or deformities.
– Check harness and connector for damage or tightness.
If any faulty condition is found in above checks, replace.